search
Cronus Zen™Zen Link™GPC Scripting

turn-upPlayStation®5 Bypass

This guide provides step-by-step instructions for setting up the PlayStation®5 bypass with Cronus Zen and DualSense™ or DualSense Edge™ controllers.

circle-check

Verified and tested with DualSense™ and DualSense Edge™ controllers for stable operation with Cronus Zen firmware.

hashtag
Step-By-Step

1

hashtag
Enable Bluetooth

  • Go to Settings → Accessories → General → Advanced Settings.

  • If Bluetooth is already set to On, as shown below, proceed to Step 2.

  • If Bluetooth is set to Off, select “Turn On Bluetooth” and press ✕ (Cross). The PS5® console will restart automatically.

2

hashtag
Connect the Controller via Bluetooth

  • Use the Bluetooth Accessories screen to connect your DualSense™ or DualSense Edge™ controller wirelessly.

3

hashtag
Selecting “Use USB Cable” Communication

  • Go to Settings → Accessories → Controller (General) → Communication Method.

  • Choose “Use USB Cable” and press ✕ (Cross) to confirm.

4

hashtag
Put the Cronus Zen in Gearhead (Idle) Mode

  • Connect the Zen to the PS5® front USB port.

  • If Zen's display shows a Gamepack or script icon, tap Zen's right blue button until the Gearhead logo appears.

circle-info

To verify that the Gearhead logo is the default screen, unplug the rear USB port cable, then reconnect it once. Confirm that the Gearhead logo remains displayed.

After verification, unplug the cable again so the Cronus Zen is no longer connected to the PS5®.

5

hashtag
Connect your Controller to the Cronus Zen

  • Connect the controller to the Zen’s A1 USB port (left-side USB).

6

hashtag
Hover over “Turn Off Accessories”

  • Go to Settings → Accessories → General → Turn Off Accessories.

  • Highlight the DualSense™ or DualSense Edge™ controller using the D-Pad. Do not press ✕ (Cross).

7

hashtag
Execute the Bypass

  • While holding Right on the D-Pad, reconnect the USB cable to the Zen’s rear USB port.

  • Continue holding for approximately five seconds until the Zen display flashes and returns to the Gearhead logo.

  • Release Right on the D-Pad.

  • Press ○ (Circle) to exit the menu and launch your game.

  • The bypass is now active.

hashtag
Disclaimers

By using this product, you acknowledge and agree to the following:

circle-info

⚠️ Trademark Notice

“PlayStation®,” “PlayStation®5,” “PS5®,” “PSN®,” and “DualSense™” are trademarks of Sony Interactive Entertainment Inc.

PreviousWirelessNextRunning Zen Studio on Linux

Last updated