GameSir G7 8K — PlayStation® Setup

Requirements

• GameSir G7 8K

• GameSir cable or dongle

• A1 Bypass or Zen Link™ in A1

• Zen Studio Live (ZSL) for checking the controller mode

---

Setup

1

Connect the controller

Connect the controller using the GameSir cable or dongle.

2

Set the polling rate

• Use: 250 Hz

• Some setups may also support: 1000 Hz

1000 Hz compatibility can vary. Use 250 Hz if 1000 Hz causes problems.

3

Switch the controller into the correct mode

Press and hold VIEW + MENU. The controller light will flash while changing modes.

For this PlayStation® setup, make sure the controller is in PC / XInput mode before using A1 / Zen Link™.

4

Check the controller mode in ZSL

Open the Device Monitor tab in ZSL. On the left-hand side, you should see Xbox One inputs.

Important: Make sure the controller is showing Xbox One inputs before continuing.

5

Set the Output Protocol

Output Protocol → Auto

---

Controller mode indicators

The controller's light indicates the current mode:

Light colour	Mode
🟢 Green / White	Connected in PC mode (XInput)
🔴 Red	Connected in Nintendo Switch® mode
🔵 Blue	Connected in Android® / PlayStation® (DS4) mode