GameSir G7 Pro — PlayStation® Setup

Requirements

• GameSir G7 Pro

• GameSir cable or dongle

• A1 Bypass or Zen Link™ in A1

• Zen Studio Live (ZSL) for checking the controller mode

---

Setup

1

Connect the controller

Connection	Switch on the back of the G7 Pro
Dongle	Towards LT
Cable	Middle position

2

Set the polling rate

Set the controller polling rate to 250 Hz.

Some G7 Pro controllers may also work correctly at 1000 Hz.

If 1000 Hz causes connection or compatibility issues, use 250 Hz.

3

Switch the controller into the correct mode

Press and hold SHARE + MENU until the controller switches mode.

4

Check the controller mode in ZSL

Open the Device Monitor tab in ZSL. On the left-hand side, you should see Xbox One inputs.

Important: Make sure the controller is showing Xbox One inputs before continuing.

5

Set the Output Protocol

Output Protocol → Auto