GameSir Tarantula 8K — PlayStation® Setup

Requirements

• GameSir Tarantula 8K

• GameSir cable or dongle

• A1 Bypass or Zen Link™ in A1

• Zen Studio Live (ZSL) for checking the controller mode

---

Setup

1

Connect the controller

Connect the controller using the GameSir cable or dongle.

2

Set the polling rate

Set to 250 Hz or 1000 Hz.

1000 Hz compatibility can vary. Use 250 Hz if 1000 Hz causes problems.

3

Switch to Xbox mode

Press and hold HOME + X until the controller changes mode.

4

Check the controller mode in ZSL

Open the Device Monitor tab in ZSL. You should see Xbox One inputs.

Important: Make sure the controller is showing Xbox One inputs before continuing.

5

Set the Output Protocol

Output Protocol → Auto